There is a lst of xbox codes for the original xbox Your original hdd is locked which is why you have error codes & most likely missing the dash. If you do see it your hdd change is going to be made easy Directly in front of that you should see a chip hovering above the mother board. Work your way back to where the grill ends. Facing the front of the xbox go to the left side & look through the grill near the front with a torch. If you have a chip you should be able to see the chip from the outside. You must extract all contents of C & E partitions by any means necessary make sure you extract two copies of each to different areas of your pc Failure to adhere to this will result in a non functioning xbox & loss of eeprom. I think that 250GB is good for me, but I don't know, any suggestion is welcome! Thank you all in advance.īefore you do anything under no circumstances make any changes to partitions or data on the hard drive that came from it. In case I do something horrible, I have already backuped all the contents of the Xbox, but what can I do in case something fails ? Can I just replace the old HD and it's allright ?Īlso which HD should I buy ? All I know it must be a IDE 3.5' (SATA ? PATA ?). Is it true? How can I prevent that or how can I check if it's not going to mess anything ?Ĭan I use a Verbatim CD-R 700mb to burn the install disc ? I know I have to use Slayer's Drive Installer but the question is: the manual says that it may corrupt the softmod. I got a 17 (or 16) error, telling me that I have to take the Xbox to maintenance. I was able to connect it via FTP, finally.īut my hard disk is 4GB, too little for my expectations, so I tried replacing it with another one. I have bought a modded XBox classic/original/first model, with EvoX and other installed Dashboards. I've found this forum while looking for guides and it has really helped me (thanks!), so I hope to find more reliable answers. Hello, first topic, I hope it's the right section.

Chimp xbox hard drive cloning software